Поделиться через


Exchange 2010 UM Troubleshooting Tool

 

Applies to: Exchange Server 2010 SP1

Topic Last Modified: 2011-03-19

The Microsoft Exchange 2010 UM Troubleshooting Tool is an Exchange Management Shell cmdlet named Test-ExchangeUMCallFlow. You can use the cmdlet to diagnose configuration errors specific to call answering scenarios and to test whether voice mail is functioning correctly in both on-premises and cross-premises Microsoft Exchange Server 2010 Service Pack 1 (SP1) UM deployments. You can use this cmdlet in deployments with Microsoft Office Communications Server 2007 R2 or Microsoft Lync Server 2010 or in UM deployments with IP gateways or IP PBXs.

Overview

This cmdlet emulates calls and runs a series of diagnostic tests that help on-premises administrators to identify configuration errors in telephony equipment, Exchange 2010 SP1 Unified Messaging settings, and connectivity issues between on-premises and cross-premises deployment of Exchange 2010 SP1 Unified Messaging.

When you run the cmdlet, it states the reason and possible solutions for issues that have been detected. It also outputs general audio quality metrics for diagnosing audio quality issues related to network connectivity such as jitter and average packet loss. The Test-ExchangeUMCallFlow cmdlet supports testing UM components in Secured, SIP Secured, and Unsecured calls, and it can be run either in Gateway or SIPClient modes.

By default, when you're running the UM Troubleshooting Tool, it uses the credentials that are used when you log on to the computer. The credentials used are those that are specified for the calling party. You must set or specify the credentials to be used when you're running the UM Troubleshooting Tool in SIPClient mode. However, you don't need to set the credentials when running the UM Troubleshooting Tool in Gateway mode. If you will be using the UM Troubleshooting Tool in SIPClient mode, there are several other Office Communications Server 2007 R2 or Communications Server "14" requirements and prerequisites that must be met. For more information, see Checklist: Deploy Office Communications Server 2007 R2 and Exchange 2010 Unified Messaging.

Important

The Test-ExchangeUMCallFlow cmdlet must be used to test only the voice mail functionality of a Microsoft Exchange Server 2010 Unified Messaging server that has Exchange 2010 Service Pack 1 (SP1) installed.

The Test-ExchangeUMCallFlow cmdlet can be installed on a local Unified Messaging server or on another 64-bit computer running:

  • The Windows Vista or Windows 7 operating system

  • The Windows Server 2008 or Windows Server 2008 R2 operating system

The Test-ExchangeUMCallFlow cmdlet requires the components below be installed on a Windows 7, Windows Vista, or Windows Server 2008 64-bit computer prior to installing the cmdlet:

The Test-ExchangeUMCallFlow cmdlet isn't included on the Exchange 2010 SP1 DVD or the Exchange 2010 SP1-only download; however, you can download the cmdlet from the Microsoft Download Center.

For more information about syntax and parameters, see Test-ExchangeUMCallFlow.